| Copies of the I/B. Please reproduce them without any |
| changes except under special instruction from Team |
| International USA. The pages must be reproduced and folded |
| in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm |
| height). When folding, make sure you keep the good |
| numbering when you turn the pages of the I/B. Don’t change |
| the page numbering. Keep the language integrity. Print only |
Fax +1 305 430 9692 | what is inside the frame. |
•When the battery’s lifetime is over and it does not charge up anymore, please send the appliance to the authorized service center of the manufacturer for replacement. Do not replace the battery yourself.
USING YOUR VACUUM CLEANER
•Once your appliance is fully charged, remove it from base, holding it by its handle.
•Switch it on by pressing the ON/OFF switch.
•Tilt the vacuum cleaner till the nozzle of the dust container is placed horizontally on the surface that is to be cleaned.
•When you are finished, press the ON/OFF switch again, to switch off the appliance, before putting it back into the charging base.
Practical hint: underneath the charging base you can find a storage compartment, where you can store the accessories supplied (crevice tool, round brush) safely and without risk of misplacing or losing them.
USING THE ACCESSORIES
Using the crevice tool:
•Insert the larger round end of the crevice tool into the nozzle of the dust container.
•Use it to clean in narrow,
•You can also use this crevice tool to
avoid scratching the nozzle of the dust container.
Using the round brush:
•First, insert the larger round end of the crevice tool into the nozzle of the dust container, as explained above.
•Then insert the square end of the round brush onto the crevice tool.
6 | HVC 39365 - 120501 |
Assembly page 6/32
