Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity.
8 USK STP 23783 - 090713
Assembly page 8/24
Fax +32 2 359 95 50
• Make sure the area to be pressed is raised and lower the pressing
plate. The raised area is the only area the plate should contact.
NOTE: Do not attempt to lower the pressing plate to its lowest
position or lock the pressing plate against the ironing board with
the pressing cushion in place. You MAY DAMAGE the steam press
by doing so.
•
Raise the pressing plate after a few seconds.
STORING
• Water may be left in the water tank, because it will not drip out if
the machine is stored in an upright position. However, it is
recommended that if the machine will be stored for some time,
that all the water in the unit should be drained by pressing the
burst of steam button until all of the water is pumped out.
• Press “ON/OFF”, the red power light will go out. Disconnect the
plug from the outlet. Leave appliance in open position.
• Wait for the steam press to cool completely (approximately 30
minutes).
• When cool, lower the pressing plate onto the ironing board
pushing the handle to its lowest position.
• Turn the locking knob to the locked position. This should prevent
the steam press from opening while being moved or stored.
• Loosely wrap the electric cord
and place it in the opening at
the front of the base of the
ironing board. You are now ready
to store the unit.
CLEANING
• To clean the pressing plate, place the pressing cushion in the
center of the ironing board. Place a clean towel over the
pressing cushion and the ironing board. Set the temperature
control to its maximum setting. When the ready light comes on
and the steam ready light goes off, gently lower the pressing
plate onto the pressing cushion. With water in the water tank,
press the burst of steam button 6 to 7 times. Be careful to avoid
touching the hot metal surfaces or leaving your hand in the bursts
of steam.