Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity.
9 USK STP 23783 - 090713
Assembly page 9/24
Fax +32 2 359 95 50
• Once the pressing plate has cooled down you can clean the
surface with a damp cloth. DO NOT use any abrasives on the
pressing plate. This pressing plate has a non-stick coating that will
assist in cleaning.
• The ironing board cover is removable for normal washing. You
can rinse the ironing board cover with mild detergent and warm
water.
The multiple function safety features of this appliance turn off electric
power to the heater when the pressing plate has been left against
the ironing board for about 10 seconds. You will hear a warning
beep. If the pressing plate is left in the open (up) position without use
after approximately 15 minutes, the unit will be automatically shut-
off. In either case, to restore the unit, you have to press “ON/OFF”
again.
E1. When the pressing plate stays closed for over 10 seconds, the
buzzer alarm rings, the digital screen shows the red flashing letters
"E1" and "Warning". The heating element will be cut off, and at this
time, only the ON/OFF button will work. To resume operation, please
just raise the pressing plate up.
E2. When the pressing plate stays raised for over 15 minutes without
any operation, the buzzer alarm will ring, the digital screen will show
red flashing letters "E2" and "Warning" only, and the heating element
will be cut off. At this time, none of the buttons will operate, and the
steam press will automatically shut off power after 5 seconds. To
resume operation, just power the steam press on again.
So when the digital screen shows red flashing letters "E1" and "E2", the
function is perfectly normal. This should not be considered as a
malfunction of the appliance.
E3. When the screen shows E3, it means the sensor line did not get
plug correctly or got loose, in this case, please contact customer
service to get the procedure to get the sensor line re-connected