Using Your
Kambrook Elite Kettle
Before first use of your new Kambrook Elite Kettle, clean the element and internal section of the container by boiling the kettle full, following the instructions below, and then discard water.
NOTE! The Kambrook Elite Kettle must only be used with the power base supplied.
To fill the kettle, open the lid by pulling up on the handle on the lid.
Fig 1
Fill the kettle to the desired level of water.
Do not fill above the max water level line or below the minimum water level line marked on the water window.
Do not over fill the kettle as this may result in boiling water being splashed out and too little water will result in the kettle switching off before the water has boiled.
Place the power base on a level, flat, surface. Plug into a 230/240V power outlet and switch on.
Ensure that the lid is locked firmly in place and then place the kettle securely onto the power base.
Push the On/Off switch down.The 'on' light will illuminate indicating that the kettle is boiling water.
Once the water is boiled the kettle will automatically switch off.
Switch off at the power outlet and then lift the kettle from the power base and pour as required using the handle.
Ensure that the power is switched off at the power outlet when the kettle is not in use.
The kettle may be stored on the power base when not in use.
CAUTION: Do not operate on an inclined surface. Do not operate unless the element is fully immersed. Do not move while switched on.
Failure to observe these cautions may result in damage to the kettle.
NOTE! Use caution when pouring water from your kettle, as boiling water will scald. Do not pour the water too quickly.
4
