USING YOUR KAMBROOK JAGUAR VACUUM CLEANER
When unpacking the vacuum cleaner unit check to see you have received all the required components, such as the hose and other accessories before discarding the packaging.
Ensure that the dust container and filters are correctly fitted.
Locate the crush proof hose and push the connection point into the hose inlet connection on the front side of the unit, until a “click” sound is heard.
Connect the wide end of the metal wand to the hose end, and push together firmly.
Fit the floor tool to the narrow end of the wand and push together firmly.
Fully extend the power cord by pulling the power plug (situated at the rear of the unit) out from the unit, until the yellow tape on the cord is shown.
ENSURE THAT YOU DO NOT OVER EXTEND THE POWER CORD – DO NOT EXTEND PAST THE RED WARNING TAPE ON THE CORD
Plug into a 230/240v power point and switch the power on.
To commence vacuuming push down on the on/off button at the top of the unit.
When vacuuming is complete, push down on the ‘on/off’ button to switch off. Turn the power off at the outlet and then remove the power cord from the power outlet. When removing plug from the power outlet grasp the plug not the cord.
To retract the cord push down on the ‘cord rewind’ to retract the cord.
IMPORTANT: HOLD THE PLUG END WHEN RETRACTING THE CORD TO PREVENT IT FROM STRIKING YOU OR THE VACUUM.
CAUTION: ALWAYS ENSURE THAT THE DUST CONTAINER AND THE MOTOR PROTECTION FILTER ARE CORRECTLY FITTED. NEVER OPERATE WITHOUT THE DUST CONTAINER AND FILTERS
IN PLACE.
CLEAN THE FLOOR TOOLS SECTION REGULARLY REMOVE HAIR, COTTON ETC FROM THE TURBO BRUSH HEAD. CUT ACROSS THE HAIR ETC AND GENTLY PULL FREE.
VARIABLE POWER CONTROL
The power booster dial on the unit is to be used for variable power control. Turn the control clockwise for maximum power for vacuuming hard floor and carpet surfaces. Turn the control
TURBO BRUSH
The Turbo Twister Brush is a floor tool which has been specifically designed to work in conjunction with your KBV70 Jaguar Turbo Twister Bagless Vacuum Cleaner. While regular floor tools do a good job at cleaning surfaces the Turbo Brush is the ideal way to clean away those hard to see dust and dirt particles that are trapped deep within carpet pile.
Fit the Turbo Brush onto the telescopic wand and follow the regular starting procedure and commence vacuuming. The suction of the cleaner starts a curved row of bristles in the brush rotating at high speed. These rotating bristles actively work to dislodge deep pile debris to provide a more effective surface clean.
The Turbo Brush has been specifically designed for removing dirt and debris from carpeted surfaces. Do not use it for any purposes, other than those stated. For optimal performance of your Turbo Brush ensure that the bristles are kept clean after use.
