Using Your Ceramic Heater
Before First Use
Remove any promotional material or packaging from the heater.
Unwind the cord to its full length and place the heater on a firm, level surface in a stable upright position. Visually inspect the air inlet and outlets to ensure there are no blockages.
Turning Your Heater On
Plug the cord into a 230V or 240V power point and switch on.
NOTE: To avoid an electrical circuit overload, it is recommended that no other appliances are plugged into the same circuit as your heater, when it is in use.
Turn the heater on by switching the On/Off 
switch located on the left hand side of the base, to the on position. An audible beep will sound, and the red power indicator light will illuminate. The heater is now in standby mode.
Setting the Heating Mode
To activate the heater, press the POWER/SWING 
button. The heater will start operating on the LOW heat setting (1100 watts) and the LCD screen will illuminate, displaying the ambient room temperature and heat setting.
NOTE: After several seconds, the LCD screen will fade, but the heater settings will remain visible.
Use the MODE 
button to select the desired heat setting. The mode button allows you to scroll through the various heating modes.
HIGH – High heat setting (1800 watts) LOW – Low heat setting (1100 watts)
AUTO – for use with the electronic thermostat
FAN – for fan only operation
To switch the heater into standby mode, press and hold the POWER/ SWING 
button until a beep sound is heard.
Turn the heater off by switching the Power 
switch located on the right hand side of the base, to the off position.
NOTE: This heater features a
8
