Using Your Snugasabug® Fitted Electric Blanket continued
Pass the controller and cord through the apertures in the skirt section of the blanket.
Ensure that when the blanket is fitted onto the mattress the controller/s and flexible power supply are outside of the bed and coverings and located in a position that will prevent accidental damage to the housing and cords
Use this blanket only as an under blanket and do not use above the occupant of the bed.
To Detach The Controller
The socket has a locking clip that engages with a small pin on the plug.
Ensure the electric blanket controller is in the ‘OFF’ position and not connected to the 230V or 240V power supply.
With the controller set to the ‘OFF’ position, push the clip out to release the socket pin and withdraw the connector plug by pulling it away from the socket.
Fixing The Removable Cover (Only KEB513 and KEB533 models)
When fixing the removable cover in position, ensure the fleecy side of the cover is on the uppermost side. Secure the removable cover using the studs fastened over the complete cover.
There should be no rucking of the removable cover when the studs are completely fastened.
No other cover other than that supplied with the blanket should be used with the electric blanket.
To Connect The Controller
Your blanket has a detachable controller and waterproof element which makes it machine washable.
Ensure the electric blanket controller is in the ‘OFF’ position and not connected to the 230V or 240V power supply.
To connect your controller, thread the detachable plug from the controller through the slot in the mesh skirt and plug it fully into the socket.
Ensure that the locking clip engages with the small plastic pin on the plug.
Storing Your Control Unit
Remove the controller when laundering your blanket. Store your controller during summer months while your blanket remains on the bed as a comfortable underblanket.
Dual Control Units
Your Double/Queen size electric blanket features two controls for individual comfort.
Turning Your Fitted Electric Blanket On
Ensure the electric blanket controller is positioned in the ‘OFF’ position. Move the switch on the controller in an upward direction and the word ‘OFF’ will be displayed.
Plug the cord into a 230V or 240V power outlet and switch the power on.
8
KEB413_IB_FA.indd 8 | 12/10/09 10:03 AM |
