Kambrook KRH300 manual Using Your Kambrook Dual Heater, Before First Use, Turning Your Heater On

Using Your Kambrook Dual Heater

Before First Use

1.Remove your heater from its carton and associated protective wrapping, and unwind the cord to its full length and remove any protective cardboard or foam that may have been used to minimize transportation damage.

2.Read and follow the complete instructions before plugging the unit into the 230-240 volt supply.

3.Remove the castors from their storage position on the base and following the directions in point 8, fit the castors so that they are positioned on the outer-most securing holes on the base of the heater. The heater must never be operated without the castors secured in the correct position.

4.Place the heater on a level surface in a stable position. Make certain the heater element control switch is in the OFF position.

5.Ensure that wheels are mounted before use.

6.Inside your box you will find two

(2)sets of caster wheels and four

(4)wing screws. To fit wheels to

heater, please turn heater up side down on an even surface. Align the two sets of the caster wheels to the holes on the bottom of the heater. Screw in the 4 wing screws and tighten by hand. Turn the heater over and use it on a stable and flat surface.

7.Plug the power cord into a 230-240 volt outlet, the red indicator light will illuminate when the power outlet is switched on.

8.Turn the Heat Control dial on the side of the heater from 0 (Off) to the desired heat setting.

IMPORTANT: Do not use the unit without the wheels fitted

IMPORTANT: Never operate the heater without the front grill securely in position.

Turning Your Heater On

This heater has 4 heat settings.

Ensure the Heat Setting dial is turned to 0 for the OFF position and Variable Thermostat dial to ‘MAX’.

Plug the cord into a 230V or 240V power point and switch on.

Setting the Heating Mode and Variable Temperature

To control the heater, turn the Heat Setting dial and Variable Thermostat dial as follows.

The Heat Setting dial has 5 modes:

0 - Shuts off the heater

1 - Low (600 watts)

2 - Med (1200 watts)

3 - Med-High (1800 watts)

4 - High (2400 watts)

The Variable Thermostat dial acts as an automatic thermostat and can be used to maintain your desired temperature.

Turn the Heat Setting dial to setting 4 and the Variable Temperature dial to ‘MAX’ setting. Once a comfortable room temperature has been reached, slowly turn the Variable Temperature dial anti-clockwise until a click sound is heard.

NOTE: The Variable Thermostat control will only operate if the heat setting is set to heat setting 3 or 4.

At this setting your heater will automatically cycle on and off to maintain the desired room temperature

Turn the heater off by turning the Heat Setting dial to 0 position.

The Heat Indicator Light will illuminate when the heater is turned to any Heat Setting from 1 to 4. It will turn off when set to 0.

NOTE: This heater features a tipover switch. If the heater tips over, the quartz heating elements will automatically switch off. The power indicator light remains on. Once placed back into the upright position, the quartz heating element will automatically switch on again.

ThermoGuard Overheating Safety Device

Your heater is fitted with a safety device that switches off the lower three quartz heating elements in the event of overheating. Should this happens, turn off the heater and inspect the air inlet and outlet for blockages. Wait at least five minutes for the over-heat protection system to reset before attempting to restart the heater.

If the heater fails to operate or the safety device switches off the lower three quartz heating elements again, return the heater to your nearest Kambrook Service Centre

for examination or repair.

8 9