the dust bag and the dust bag indicator will indicate full. If this happens the bag could appear relatively empty, however the bag will still need to be changed to avoid strain on the motor.
NOTE:The bag compartment lid may not close if the bag is not correctly fitted.
IMPORTANT: DO NOT USE THE UNIT WITHOUT A DUST BAG IN PLACE
Replacing filters
Filters must be cleaned from time to time to remove the fine dust particles that have been collected.This can be done by shaking them; however after approximately 5 dustbag changes the filters should be replaced.
Motor protection filter
The motor protection filter must always be in place when operating the vacuum otherwise damage to the motor may occur
To replace the motor protection filter – Remove the dustbag or pull the bag forward.The motor protection filter is located at the rear, right hand side of this inner chamber. Pull the filter upward to remove and push downwards to insert.
The HEPA filter must be replaced after multiple use. Lift the lid of the filter housing and lift the filter in an upward position.To replace the filter, place in a descending position lowering the filter until it is firmly in place.
Care and Maintenance
Always switch appliance off, then switch off at the power outlet and then unplug the appliance prior cleaning or replacing either filter.
To clean the outside of the unit, wipe the exterior with a soft, damp cloth. Never use an abrasive cleaner.
Check and replace both the motor protection and HEPA dust filters on a regular basis.
From time to time hair, cotton and other items may get caught in the brushes of the floor head.To remove such items, take a pair of scissors and cut across the cotton, hair, etc to loosen, then gently pull to remove.
NOTE: Do not continue to pull if the item/s does not easily come out as this may permanently damage the floor tools.
6
