Commissioning and operation, Safety Devices, Power switch

containing water or dirt.

Caution

In case of extended downtimes, switch the appliance off at the main switch / ap- pliance switch or remove the mains plug.

Do not operate the appliance at temper- atures below 0 °C.

Observe a distance of at least 30 cm when using the jet to clean painted sur- faces to avoid damaging paintwork.

Never leave the appliance unattended when it is in operation.

Make sure that the power cable or ex- tension cables are not damaged by run- ning over, pinching, dragging or similar. Protect the power cable from heat, oil, and sharp edges.

All current-conducting parts in the work- ing area must be protected against jet water.

The appliance may only be connected to an electrical supply which has been installed in accordance with IEC 60364.

The appliance may only be connected to alternating current. The voltage must correspond with the type plate on the appliance.

The maximum tolerable mains imped- ance at the electrical contact point (see Technical Data) must not be exceeded.

For safety reasons, we recommend that you operate the appliance only via a earth-leakage circuit breaker (max.

30 mA).

Cleaning operations which produce oily waste water, e.g. engine washes, un- derbody washes, may only be carried out using washing stations equipped with an oil separator.

This appliance was designed to be used with detergents which are supplied or recommended by the manufacturer. The use of other detergents or chemi- cals may compromise the safety of the appliance.

Safety Devices

Caution

Safety devices protect the user and must not be modified or bypassed.

Power switch

The appliance switch prevents unintention- al operation of the appliance.

Lock trigger gun

This lock locks the lever of the trigger gun and prevents the inadvertent start of the ap- pliance.

Overflow valve with pressure switch The overflow valve prevents the permissi- ble working pressure from being exceeded. If the lever on the trigger gun is released the pressure switch turns off the pump, the high-pressure jet is stopped. If the lever is pulled the pump is turned on again.