from water butts or ponds (see specifica- tions for max. suction height).
ÎFill the KÄRCHER suction hose with backflow valve with water, screw to wa- ter supply and hang into he water butt.
ÎSeparate the high pressure hose from the high pressure connection of the ap- pliance.
ÎSwitch the appliance on (I/ON) for a max. of 2 minutes and wait until the wa- ter exits the
ÎTurn off the appliance "0/OFF".
Start up
Caution
Dry runs lasting longer than two minutes lead to damages to the high pressure pump. If the appliance does not build up pressure within two minutes, switch it off and proceed as instructed in the Chapter "Help with faults".
ÎConnect the high pressure hose to the high pressure connection of the appli- ance.
ÎPush the spray lance into the trigger gun and fasten it by turning it through 90°.
ÎCompletely open the water tap.
ÎInsert the mains plug into the socket.
ÎTurn on the appliance “I/ON”.
Operation
Danger
The trigger gun is subjected to a recoil force when the water jet is discharged. Make sure that you have a firm footing and are also holding the trigger gun and spray lance firmly.
ÎUnlock the lever on the trigger gun.
ÎPull on the lever of the trigger gun; the device will switch on.
Note: Release the lever of the trigger gun; the device will switch off again. High pres- sure remains in the system.
Spray lance with pressure regulation Carrying out the most common cleaning tasks. The work pressure can be stageless- ly regulated between "Min" and "Max".
ÎRelease the lever on the trigger gun.
ÎTurn the spray lance to the desired po- sition.
Spray lance with Dirtblaster
For particularly dirty items or areas. Not suitable for use with detergents.
Operation with detergent
Please use exclusively KÄRCHER deter- gents and care products to carry out the re- spective cleaning task, as these were specifically developped for your appliance. The use of other detergents and care prod- ucts may lead to premature wear and can invalidate your warranty claims. Please ob- tain information at your local dealer or re- quest information directly from KÄRCHER.
ÎUse spray lance with pressure regula- tion (Vario Power).
ÎTurn the spray lance to "Mix" position - low pressure.
ÎFill the detergent solution in the deter- gent tank (observe dosage instructions on the packaging of the detergent).
ÎAdjust the suction volume of the deter- gent solution by means of the dosage regulator for detergents.
Turning the regulator to the left: Addi- tional dosage from the left detergent tank.
Turning regulator to the right: Additional dosage from the right detergent tank.
Recommended cleaning method
ÎSpray the detergent sparingly on the dry surface and allow it to react, but not to dry.
ÎSpray off loosened dirt with the high- pressure jet.
English 7
