Caution
Observe a distance of at least 30 cm when using the jet to clean painted sur- faces to avoid damaging paintwork.
Never leave the appliance unattended when it is in operation.
Make sure that the power cable or ex- tension cables are not damaged by run- ning over, pinching, dragging or similar. Protect the power cable from heat, oil, and sharp edges.
All
The appliance may only be connected to an electrical supply which has been installed in accordance with IEC 60364.
The appliance may only be connected to alternating current. The voltage must correspond with the type plate on the appliance.
For safety reasons, we recommend that you operate the appliance only via a
30 mA).
Cleaning operations which produce oily waste water, e.g. engine washes, un- derbody washes, may only be carried out using washing stations equipped with an oil separator.
This appliance was designed to be used with detergents which are sup- plied or recommended by the manufac- turer. The use of other detergents or chemicals may compromise the safety of the appliance.
Operation
Before Startup
Illustrations on Page 3
Illustration
ÎPull out the clamp for the
Illustration
ÎConnect high pressure hose to trigger gun.
ÎPush the clamp in until it locks. Check the secure connection by pulling on the
Water supply
According to the applicable regula- tions, the appliance must never be used on the drinking water supply without a system separator. Use a suitable system separator manufactured by Kärcher; or, as an alternative, a system separator as per EN 12729 Type BA. Note: Impurities in the water can damage the
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/tech- nical data.
ÎUse a
ÎScrew the water filter on the water con- nection of the device.
ÎScrew the delivered coupling part on the water filter.
ÎPush the water supply hose onto the coupling unit, then connect it to the tap.
6English