Kathrein UFD 346 operating instructions Tone Burst and DiSEqC Signal, DiSEqC Repeat, Remote

Basic Setting-up

Tone Burst and DiSEqC Signal

If a reception-system uses more than 4 control-criterions, then a DiSEqC control- signal is required.

Which setting-up option, ”Tone Burst” or ” DiSEqC” is required depends upon the components in your reception system.

Read the description of the fitted reception-system components (switching-matrix).

Tone Burst

The menu-option ”Tone Burst” allows the following settings for the 22 KHz signal:

Default switching status :
22 KHz signal	→ High/Low and
Tone Burst	→ Pos. A/B:
Low	22 KHz	Off
High		On
Pos. 1	Tone Burst	0
Pos. 2	Tone Burst	1

Default switching status:
22 KHz signal		→	Pos. A/B and
Tone Burst		→	Opt. A/B
Pos.	Tone Burst			22 KHz
1		0		Off
2		0		On
3		1		Off
4		1		On

DiSEqC

With the DiSEqC-Signal, the switching options are again enhanced

To ensure a perfect setting-up, you must know the reception-system switching- criterions.

Read the description of the DiSEqC-matrixes and contact your qualified reception- system technician.

DiSEqC Repeat

The DiSEqC command must be repeated if the satellite reception-system contains cascaded "DiSEqC components" (DiSEqC matrixes consecutively switched).

∙Switch the menu option "DiSEqC repeat" to "On".

Remote

The setting ”Remote” in menu-option ” DiSEqC” is for planned future modifications. If the receiver UFD 346 is connected to a reception-system with a ”subscriber con- trolled signal processing system e.g. ”Kathrein UFO mini digital ”, then Remote must be selected from the DiSEqC menu.

In this case the corresponding upper carrier frequency in the range 920 - 2150 MHz must be selected from the menu option ”Remote Frequency”. With this fre- quency the satellites signals are transferred from the reception-system to the re- ceiver.

∙Press this button twice, to save your settings.

∙Press this button twice, to exit the basic setting-up menu.

Important The settings will be lost if you exit the menu without saving!

25