Setting Up Video Endpoints

Procedure 2: Add a Signaling Group for the Video Trunk

To add a signaling group for the video trunk:

1.Use the add signaling-groupxx command (where xx is the chosen signaling group) to access the Signaling Group form.

The Signaling Group form appears.

2.Set Group Type to h.323.

3.Set IP Video to y.

4.Set Near-end Listen Port.

5.Set LRQ Required to n.

6.Set Far-end Node Name.

7.Set Far-end Listen Port.

8.Set the Far-end Network Region. If you set the maximum bandwidth for video calls in Procedure 3, assign that IP network region.

9.Set Calls Share IP Signaling Connection to y.

Note:

You must set this parameter to y.

10.Set Direct IP-IP Audio Connections to y.

11.Set IP Audio Hairpinning to y.

Procedure 3: Add a Trunk Group

To add a trunk group:

1.Use the add trunk-groupxx command (where xx is the chosen trunk group) to access the Trunk Group form.

The Trunk Group form appears.

2.Set Group Type to isdn.

3.Perform one of the following steps:

For Avaya Communication Manager Release 3.01, set Carrier Medium to IP.

For Avaya Communication Manager Release 3.1 or later, set Carrier Medium to H.323.

4.Go to page 5 of the Trunk Group form.

5.Add members to the trunk group.

132 Avaya Video Telephony Solution Networking Guide

Page 132
Image 132
Avaya 16-601423 manual Procedure 2 Add a Signaling Group for the Video Trunk, Procedure 3 Add a Trunk Group