Q-Logic FIRMWARE VERSION 7.4 manual A3006.0001-000C value voltage sensor shows valueV Alarm SET

3 – Event Messages Alarm Events

S

(A3005.0001-000C) (Blade fault (valueV_HIGH - The [value]V voltage supply is out of range, it is too high)

Meaning:	A high voltage blade fault has occurred on a SANbox 9000 switch.
Action:	Contact your authorized maintenance provider.
(A3006.0001-000C) (value voltage sensor shows valueV - ALARM SET)
Meaning:	An out-of-range voltage condition has occurred on a SANbox 5000
	switch.
Action:	Contact your authorized maintenance provider.

(A3006.0001-000C) (Blade fault (valueV_LOW - The valueV voltage supply is out of range, it

is too low)
Meaning:	A low voltage blade fault has occurred on a SANbox 9000 switch.
Action:	Contact your authorized maintenance provider.

(A3007.0001-000C) (value voltage sensor shows valueV - ALARM CLEAR)

Meaning: The out-of-range voltage condition on a SANbox 5000 series switch has cleared.

Action: None

(A3007.0001-000C) (Blade fault (blade_fault - CLEARED)

Meaning: The high or low voltage SANbox 9000 blade fault has cleared.

Action: None

(A3008.0000) (The configuration area was damaged or a Remake Filesystem was performed from PROM mode. You must perform a 'config restore' to clear this error.)

Meaning:	The configuration area was damaged or a Remake Filesystem was
	performed from Maintenance mode.
Action:	Enter the Config Restore command to clear the error. If this does
	not correct the problem, contact your authorized maintenance
	provider.

(A3014.0001) (Blade in slot slot_number set Down due to failure of all AuxPorts)

Meaning:	The blade in the named slot has isolated because all auxiliary ports
	to the cross-connect blades have failed.
Action:	Contact your authorized maintenance provider.

(A3014.0002) (Blade in slot slot_number set Online due to internal failure recovery)

Meaning:	The blade in the named slot has recovered at least one auxiliary
	port to a cross-connect blade and is no longer isolated.
Action:	None

3-44 59060-05 A