Q-Logic FIRMWARE VERSION 7.4 manual A1005.0063 CPU never entered HotStandby state

A

3 – Event Messages Alarm Events

(A1005.005E) (Canceling Services edit mode as a result of a CPU switchover)

Meaning:	A CPU blade switchover occurred while a services edit session
	was in progress. The edit session was canceled.
Action:	Reopen the services edit session.

(A1005.005F) (Canceling Nicknames edit mode as a result of a CPU switchover)

Meaning:	A CPU blade switchover occurred while a nicknames edit session
	was in progress. The edit session was canceled.
Action:	Reopen the nicknames edit session.

(A1005.0060) (A control link between blade_ID and blade_ID (via blade_ID) has failed, blade control is not fully redundant, contact technical support.).

Meaning:	A portion of the control plane network on the switch has failed. The
	switch should continue to function normally, but any further failures
	may cause the switch to malfunction.
Action:	Contact your authorized maintenance provider.

(A1005.0061) (A control link between blade_ID and blade_ID (via blade_ID) is now functioning normally.

Meaning:	The control link has recovered and is functioning normally.
Action:	None
(A1005.0063) (CPU never entered HotStandby state)
Meaning:	Secondary CPU never entered Hot Standby state, and therefore
	the switch is not fault tolerant.
Action:	Contact your authorized maintenance provider.

(A1005.0064) (Switch is not fault-tolerant. Fault Tolerant license is installed, but only 1 CPU blade installed)

Meaning:	The Fault Tolerant license key was installed on a SANbox 9000
	switch with only one CPU blade.
Action:	Install the second CPU blade.

(A1005.0065) (Fault Tolerant license is installed, but secondary CPU's latch is open so unable to become Fault Tolerant)

Meaning:	The SANbox 9000 switch is not fault tolerant because the
	secondary CPU blade is not fully installed.
Action:	Close the secondary CPU blade latch.

59060-05 A 3-27