Q-Logic FIRMWARE VERSION 7.4 manual EPort will be reset in an attempt to reestablish the ISL

3 – Event Messages Warning Events

S

(W)(8700.000A) (EPort) (Port: port_number) (No response from remote switch, resetting

Inter-Switch Link (ISL))

Meaning:	No communication has been received from the remote switch for
	some time, indicating that it may not be functioning properly. The
	E_Port will be reset in an attempt to reestablish the ISL.

(W)(8B00.000D) (SMTP servers in the CallHome setup are using duplicate IP address and port number pairs)

Meaning:	The Call Home service configuration must not duplicate both the
	Simple Mail Transfer Protocol (SMTP) server IP address and port
	number values. However, the configuration may duplicate either
	the server IP address or the port number. For better fault tolerance,
	the SMTP servers should run on different physical systems. The
	port number value of 25 is the well-known service number for the
	SMTP protocol.

(W)(8B00.000E) (Message queue is empty, cancelling attempts to retry sending last message)

Meaning:	The Call Home service was waiting to resend a message when the
	message expired, or there was a request to clear the queue of all
	messages.

(W)(8B00.000F) (Will retry sending via SMTP server ip_address, port port_number, after seconds seconds)

Meaning:	After a communication failure or Simple Mail Transfer Protocol
	(SMTP) protocol error, the switch attempts to resend the e-mail
	message using the specified server, port, and delay.

(W) (8B00.0010) (Will retry sending via SMTP server ip_address, port port_number)

Meaning:	After receiving a transient error from the Simple Mail Transfer
	Protocol (SMTP) server on a e-mail message sent to a recipient,
	the Call Home service will attempt to resend the e-mail message.

(W)(8B00.0011) (SMTP addresses are defaults or disabled, will not retry sending messages until a valid SMTP address has been configured and enabled)

Meaning:	Either both Simple Mail Transfer Protocol (SMTP) server IP
	addresses in the Call Home service configuration are the default
	value (0.0.0.0), or they have not been enabled.

3-62 59060-05 A