Q-Logic FIRMWARE VERSION 7.4 manual A1005.004C ICCnumber cable installed Alarm Cleared

3 – Event Messages Alarm Events

S

(A1005.0042) (Target device port_address attached to port port_number with

IOStreamGuard Enabled)

Meaning:	The target device is attached to a port with IO StreamGuard
	enabled.
Action:	Disable I/O StreamGuard on the port.

(A1005.0045) (Configured port data conflicting within hardware capabilities)

Meaning:	Configured port settings conflict with the hardware capabilities of
	the port. The port is down.
Action:	Reconfigure the port to be compatible with the port hardware.

(A1005.0047) (Attempts to login backend switch fail because backend switch does not support NPIV.)

Meaning:	The backend fabric switch does not support N_Port ID
	Virtualization (NPIV) which in turn brings down the TF_Port.
Action:	Ensure that the backend fabric switch supports NPIV.

(A1005.004A) (Temporary license for Fabric Security will expire in hours hour(s))

Meaning:	The temporary Fabric Security license will expire in the time
	displayed.
Action:	Purchase and install the Fabric Security license to continue using
	the security feature.

(A1005.004B) (The switch was reset due to firmware upgrade issues)

Meaning:	After a firmware upgrade, the Serial Prom Cyclic Redundancy
	Check (CRC) did not match what was expected. It is likely that
	licenses were updated on the switch while running older firmware.
Action:	Check your license configuration for changes.

(A1005.004C) (ICCnumber cable installed - ALARM CLEARED)

Meaning:	A HyperStack cable has been connected to the specified
	Inter-Chassis Connection (ICC) port and the associated alarm has
	been cleared.
Action:	None

(A1005.004D) (ICCnumber cable not installed - ALARM SET)

Meaning:	A HyperStack cable is not connected to the specified Inter-Chassis
	Connection (ICC) port and the associated alarm has been set.
Action:	None

3-24 59060-05 A