Q-Logic FIRMWARE VERSION 7.4 manual Remote switch. All switches in the fabric must have the same

A

3 – Event Messages Alarm Events

(A1007.0026) (Unable to validate Chap Response from device_WWN, possible Chap secret misconfiguration or security breach attempt.)

Meaning:	A Challenge Handshake Authentication Protocol (CHAP)
	authentication attempt failed due to failure while comparing
	secrets.
Action:	Check security configuration.

(A1007.0027) (Radius server could not validate authentication response from port_number)

Meaning:	Remote Authentication Dial In Service (RADIUS) authentication
	failed.
Action:	Confirm that the secret is the same on the switch as it is on the
	RADIUS server.

(A1007.0028) (Security: 2-Way Authentication, No security entry found for port)

Meaning:	Unable to locate a security member entry to complete a two-way
	authentication.
Action:	Edit the group to include the port.

(A1007.0029) (Security protocol not using chap, unable to authenticate.)

Meaning:	A Challenge Handshake Authentication Protocol (CHAP) negotiate
	frame that specifies an unsupported authentication protocol was
	received.
Action:	Check the remote device for a possible error condition. Reset the
	port to try again. If errors continue, disable CHAP for this device if
	the device belongs in the fabric.

(A1007.002A) (Inconsistent Fabric Binding configuration. Enabled on remote switch(s), disabled on local switch.

Meaning:	Inconsistent fabric binding configuration settings between local and
	remote switch. All switches in the fabric must have the same
	configured fabric binding setting.
Action:	Enable or disable fabric binding on all switches.

59060-05 A 3-37