Q-Logic FIRMWARE VERSION 7.4 manual A1007.001C Security Bad Authentication Flags

A

3 – Event Messages Alarm Events

(A1007.0013) (Response from address FC_address, lacks authentication, discarding)

Meaning:	A response received on the indicated port lacked Common
	Transport (CT) authentication.
Action:	Verify that the CT security configuration of the management
	application using the remote port is compatible with the
	configuration of the Management Server security group on the
	switch.

(A1007.0014) (Response from WorldWide Name (WWN) device_WWN address FC_address, failed authentication, discarding)

Meaning:	A request received on the indicated port failed Common Transport
	(CT) authentication.
Action:	Verify that the CT security configuration of the management
	application using the remote port is compatible with the
	configuration of the Management Server security group on the
	switch.
(A1007.001C) (Security: Bad Authentication Flags)
Meaning:	The received AUTH frame did not meet the standard format for the
	frame payload. Within the header portion of the payload, there are
	some flags that are supposed to be set to zero (0). This frame has
	the flags set to something other than zero (0).
Action:	Check the remote device for a possible error condition. Reset the
	port to retry again. If errors continue, disable Challenge Handshake
	Authentication Protocol (CHAP) for this device if it belongs in the
	fabric.
(A1007.001D) (Ignoring RADIUS Server Radius_Server, invalid IP address configured)
Meaning:	A Remote Authentication Dial In Service (RADIUS) server could
	not be found at the configured IP address.
Action:	Check the RADIUS server, or change the configuration to use an
	IP address for a valid RADIUS server.

(A1007.001F) (Access reject from RADIUS server IP_address:port for device on this port)

Meaning:	Security authentication has reached the maximum retry count. The
	port will now isolate.
Action:	Check the security configuration.

59060-05 A 3-35