Q-Logic FIRMWARE VERSION 7.4 manual Standard layout of the frame or the Challenge Handshake

3 – Event Messages Alarm Events

S

(A1007.002B) (Security: Chap session Negotiate Authentication failed)

Meaning:	The local switch received an authentication negotiate frame which
	failed processing. Either the payload of the frame did not match the
	standard layout of the frame or the Challenge Handshake
	Authentication Protocol (CHAP) session between the devices
	being authenticated was not in the state where the negotiate frame
	was expected.
Action:	Check the remote device for a possible error condition. Reset the
	port to retry again. If errors continue, disable Challenge Handshake
	Authentication Protocol (CHAP) for this device if it belongs in the
	fabric.

(A1007.002C) (Security: Authentication protocol msg (AUTH_DONE) inconsistent with Authentication protocol in progress)

Meaning:	The local switch received an AUTH_DONE command
	authentication frame while the Challenge Handshake
	Authentication Protocol (CHAP) session was not in the correct
	state to expect this type of frame. The remote device is not
	following standard authentication protocol.
Action:	Check the remote device for a possible error condition. Reset the
	port to retry again. If errors continue, disable CHAP for this device
	if the device belongs in the fabric.

(A1007.002D) (Ignoring RADIUS Server RADIUS_server, invalid UDP port configured)

Meaning:	A Remote Authentication Dial In Service (RADIUS) server was
	configured with invalid data for the User Datagram Protocol (UDP)
	port. This configuration field is required to use the RADIUS server.
Action:	Set the UDP port value in the switch RADIUS server configuration
	using the Set Setup Radius command.

(A1007.002E) (Ignoring RADIUS Server RADIUS_server, zero timeout configured)

Meaning:	A Remote Authentication Dial In Service (RADIUS) server was
	configured with invalid data for the timeout value. A valid time out
	value is required to use the RADIUS server.
Action:	Set the timeout value in the switch RADIUS server configuration.
	using the Set Setup Radius command.

(A1007.002F) (Ignoring RADIUS Server RADIUS_server, no shared secret is configured)

Meaning:	A Remote Authentication Dial In Service (RADIUS) server was
	configured with invalid data for the shared secret. A valid time out
	value is required to use the RADIUS server.
Action:	Set the shared secret in the switch RADIUS server configuration.
	using the Set Setup Radius command.

3-38 59060-05 A