Configure a Polycom MGC-25 Video Conferencing Bridge Platform for an Avaya S8300 Server
Issue 3 January 2008 81
d. In the Service Mode box, enter Pseudo Gatekeeper AVF.
Note:
Note: If Pseudo Gatekeeper AVF does not appear, you do not have the latest
software. You must install the Avaya-enabled Polycom MGC Manager software.
e. In the Prefix box, enter the first digit of the extension numbers range in which the MCU
resides.
f. Select the Refresh H.323 Registrations check box, and select 120 seconds.
8. On the Spans tab, add a new IP Span.
a. In the Circuit ID box, enter a unique identifier for this new circuit.
b. In the IP Address box, enter the IP address of the IP card that will use H.323 signaling.
c. In the H323 Alias 1 box, enter an H.323 ID of an alias for the board that Avaya
Communication Manager will route calls to this MGC.
9. Define the IP1 configuration. In the Circuit ID box on the IP-Network Parameters tab, enter
the unique identifier you specified in Step 6.
10. Create a meeting room in Meeting Rooms and Entry Queues. In the Numeric ID box on
the General tab, enter the dialed digits excluding the prefix defined in the Network Service.
If you want to configure Ad-hoc conferencing for the MGC system, go to Configure Ad-hoc
Video Conferencing for a Polycom MGC Video Conferencing Bridge Platformon page 89.