Page
33
3.Place the piano on the front half of the stand so that the metal fitting holes are seen when viewed from the top. Slide the piano backward while holding it with one hand so that it does not incline and fall from the stand. The hooks on the piano are then engaged with the metal fittings on the Side Panels. Pay attention so that hands or fingers are not caught between the stand and piano. Fasten the piano and the stand with four bolts (with plain washers and spring washers)(F').
First, loosely tighten the bolts to adjust the unit position in order to make sure that all four bolts can be inserted straight. Then, tighten the bolts.
Make sure that the bolts are tightened until the spring washers collapse.
Hand or Finger catching hazard
(F')
Caution y Ensure that the CN21 piano is correctly secured to the stand by using the bolts included. Failing to do so may result in the unit falling from the stand, causing damage or personal
injury.
4.Insert the pedal connection cord that comes from Pedal Board (C) into the piano's pedal jack and fasten with cord clamps.
backside of the unit | Cord | |
clamp | ||
|
Pedal jack
Pedal cord connector Locking tab
5.Fix the headphone hook to the location marked with red ink by using two tapping screws provided in the same plastic bag.
Red mark
APPENDICES
6
6.Turn the Adjuster (installed on the bottom of C) until it touches the floor to support the pedal board.
Caution y The pedal board may break if the adjuster is not touching the floor correctly. When
moving the CN21 piano, ensure that the the unit is lifted clearly from the floor and not dragged.
Pedal board
Floor
Adjuster
