CHARGING BATTERY PACK
CHARGE
BATTERY PACK:
1. Plug the charger
into the nearest
120 volt electri-
cal outlet.
2. Make sure the
trigger on the
Cordless
Impact Wrench
is in the “OFF”
position and remove the
battery pack from the Cordless Impact Wrench.
3. Insert the battery pack into the charger. Be sure that the battery pack is
fully seated in the charger. Do not force.
4. The red indicator light should come “ON” indicating that the battery pack is in
a “Fast Charge” mode. If the green indicator light comes “ON”, then the battery
is already fully charged.
5. After approximately one hour of charging, the red indicator light should go
“OFF” and the green light should come “ON” indicating that the battery is fully
charged and the charger is now in a “Trickle Charge” mode.
6. The battery can be left in a “Trickle Charge” mode until ready to use.
IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES
When using your Cordless Impact Wrench continuously, the batteries in your bat-
tery pack will become hot. You should let a hot battery pack cool down for approxi-
mately 30 minutes before attempting to recharge. When the battery pack becomes
discharged and is hot, the red light on the charger will flash. When the battery
pack cools down, the red light will glow continuously to indicate fast charging
mode, 1-hour charge time.
This will occur when continuous use of your Cordless
Impact Wrench causes the battery pack to become hot. It does not occur
under normal circumstances.
12
REMOVING/ ATTACHING BATTERY PACK
REMOVE BATTERY PACK:
1. Press both release
buttons on either side
of the Cordless Impact
Wrench to release the
battery pack.
2. Pull battery pack free of
Cordless Impact Wrench.
ATTACH BATTERY PACK:
1. Align the raised portion of the
battery pack with the groove in
the battery compartment of the
Cordless Impact Wrench.
2. Press the battery pack into place. Make sure the latches
are securely fastened. Do not use the Cordless Impact
Wrench if the battery pack is not seated properly.
CHARGER
Before using battery charger, please read carefully all
instructions and cautionary markings on battery charger, battery pack and
product using battery.
Use only the charger which accompanied your product or direct replacement as
listed in this manual. Do not substitute any other charger. Use only Alltrade
approved chargers with your product.
Do not disassemble charger.
Do not use charger if it has been damaged, left outdoors in the rain, snow, wet
or damp environments, or immersed in liquid.
The battery pack and charger heat during charging. Place the charger on a flat,
non-flammable surface away from flammable materials with at least four inches of
clearance to allow proper air circulation around the charger and battery pack.
When the battery pack requires recharging, a 1 hour charge allows the tool to
operate at full power. A charging indicator light on the charger will illuminate to
show that charging is taking place.
11
RELEASE BUTTON
BATTERY INDICATOR
HighMedLow
BATTERY PACK
LED LIGHT
BATTERY
CHARGER
RELEASE BUTTON
(PRESS)