If the bit becomes bound in the work piece, release the trigger immediately and prepare for the tool to kickback toward you. Reverse the direction of rota- tion, then back out the bit by slowly squeezing the trigger.
Make sure all accessories are rated for the recommended speed of the drill. Brushes, grinding wheels and other accessories may fall apart if run at too high a speed, sending dangerous debris flying at the operator.
Never wear gloves when operating the drill. Use gloves only when changing hot bits and accessories to avoid burns.
Hammer bits and tools get hot during operation. Wear gloves when touching them.
Do not use in damp or wet locations. Do not operate tool in an explosive atmosphere, such as in the presence of flammable liquids, gases or dust. Power tools create sparks, which may cause an explosion or fire.
SYMBOLS
IMPORTANT: Some of the following symbols may be used on your tool. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the tool better and safer.
SYMBOL | NAME | EXPLANATION | |||||
|
| V | Volts | Voltage (Potential) | |||
|
| A | Amperes | Current | |||
| Hz | Hertz | Frequency (Cycles per Second) | ||||
| W | Watt | Power | ||||
| Kg | Kilograms | Weight | ||||
|
|
|
|
|
| Alternating Current | Type of Current |
|
|
|
|
|
| Direct Current | Type of Current |
|
|
|
|
|
| ||
|
|
|
|
|
| Alternating or Direct Current | Type of Current |
|
|
|
|
|
| Earthing Terminal | Grounding Terminal |
|
|
|
|
|
| ||
|
|
|
|
|
| Class II Construction | Denotes Double Insulation |
| min | Minutes | Time | ||||
|
| s | Seconds | Time | |||
| Diameter | Size of Drill Bits, | |||||
|
|
|
|
|
|
| Grinding Wheels, etc. |
|
|
|
|
|
| No load speed | |
.../min | Revolutions per Minute | Revolutions, Surface Speed, | |||||
|
|
|
|
|
|
| Strokes, etc. per Minute |
1,2,3, … | Ring Selector Settings | Speed, Torque or Position Settings | |||||
FUNCTIONAL DESCRIPTION
8
1
7 | 3 |
| |
| 5 |
| 2 |
| 6 |
| 4 |
11
9
10
|
|
| 12 |
CONTROLS AND COMPONENTS: |
|
| |
1. | 1/2" Variable Speed | 10. | Chuck Key |
2. | 13mm (1/2") Chuck | 11. | Chuck Key Holder |
3. | Speed Control Adjusting Switch | 12. | Power Cord |
4.On/Off Switch
5.
6.Forward/ Reversing Switch Lever
7.Adjustable Side Handle
8.Hammer / Drill Selector
9.Depth Gauge
ASSEMBLY
Disconnect the power plug from the AC power source before any assembly, adjustments, or adding/removing accessories. Following this preventative step reduces the risk of the drill coming on acciden- tally and the risk of damage to the workpiece and injury to the operator.
7 | 8 |
