ATTACHING AUXILIARY HANDLE
This tool comes with an auxiliary handle which can be attached to either side of the Angle Grinder, depending on the preference of the operator. This handle is necessary to maintain complete control of the tool and should be used at all times. Make sure this handle is always fastened securely.
ATTACHING WHEEL GUARD
Never brush or grind without the guard in place. Brushes are considered to be grinding wheels and must also be used with guards.
•Always unplug the tool before attempting to change the guard or accessories.
•Set the Angle Grinder on a flat surface with the spindle facing up.
•Place the spring washer of the guard over the spindle.
•Tighten the screw of the spring washer.
•Make sure that the guard is securely tightened in place.
9
ATTACHING WHEELS WITH DEPRESSED CENTERS
WARNING Always check the tool warning label for the recommend- ed speed rating on accessories. Never run a wheel or brush over the rated speed. Accessories exceeding the recommended speed may fly apart and cause serious personal injury.
Hubbed wheels do not require mounting flanges.
SPINDLE
LOCK
BUTTON
•Check to make sure that the guard is fitted properly. Put the inner flange on the spindle.
•Put the grinding wheel on the spindle and the inner flange.
•When working with thin grinding wheels, fit the threaded outer flange with the raised area facing toward the wheel.
•When working with thick grinding wheels, fit the threaded outer flange with the raised area facing away from the wheel.
•Push in the spindle lock button. Turn the outer flange until it locks into place.
•Once the spindle is locked, insert the enclosed wrench into the holes of the outer flange to tighten the outer flange properly.
