VARIABLE SPEED TRIGGER SWITCH
TORQUE SETTINGS
THIS TOOL IS CONTROLLED
BY A TRIGGER SWITCH:
•The speed of the Cordless Drill depends on the amount of pressure you put on the trigger.
•The more pressure you apply, the faster the Cordless Drill will go.
•Release the pressure and the Cordless Drill will slow down.
TRIGGER SWITCH
LED LIGHT
To prevent damaging the tool or driving screw too deep into work piece, release the trigger when you feel the clutch slip.
THE CONTROL RING ADJUSTS THE LEVEL OF TORQUE: | CONTROL RING |
• For light duty work, use lower settings.
• For heavy duty work, use higher settings.
PROPER SETTING FOR DRIVING SCREWS:
1. Set the ring on the lowest
BUILT IN LED LAMP
• Press the trigger switch to light up the lamp. The lamp remains on while the trigger
switch is being pressed. The lamp goes out after releasing the trigger.
NOTE: Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination.
Do not look into light or see the source of light directly.
FORWARD / REVERSE AND TRIGGER LOCK LEVER
Be sure the trigger is released when changing the position of the lever. Always store the tool in the “LOCKED/OFF” position.
Always check the direction of the Cordless Drill's rotation before use.
setting to begin.
2.Try tightening the first screw. If the drill drives smoothly, proceed with the next screw.
3. If the Drill’s clutch slips, increase the torque setting
and try again until the Drill drives the screw without incident.
HIGH / LOW SPEED (GEAR) SHIFTING |
| |
FOR LOW SPEED SETTING: | LOW SPEED | HIGH SPEED |
• Slide the switch on top of | ||
the Drill to Position 1 for |
|
|
high torque applications and |
|
|
driving screws. |
|
|
FOR HIGH SPEED SETTING:
TO SELECT THE DIRECTIONS OF ROTATION:
•To select forward Cordless Drill rotation, press the trigger lock from left to right flat against the Cordless Drill body.
| FORWARD |
| LOCK |
TRIGGER | REVERSE |
LOCK |
|
•Slide the switch to Position 2 for light duty projects.
•To select reverse, press the trigger lock lever in the opposite direction.
•The center position locks the tool.
15 | 16 |