|
| 2 Preparation |
Permanently setting | It is easy to permanently adjust the amount of water and milk for all | |
amounts for the cup size | products to the cup size. Adjust the amount once as shown in the | |
|
| following example. Every time you prepare a drink in the future, this |
|
| amount will be dispensed. |
|
| The permanent settings for adapting the amounts to the cup size |
|
| for all products follow this model. |
|
| Example: Proceed as follows to permanently set the amount of |
|
| water for one coffee. |
|
| Precondition: ‘Please select product:’ is displayed. |
|
| T Place a cup under the coffee spout. |
|
| |
|
| |
|
| TPress and hold the ‘Coffee’ button. |
|
| ‘Coffee’ and the fill volume are displayed. |
|
| T Hold the ‘Coffee’ button down until ‘Enough coffee? Press |
|
| button.’ appears. |
|
| TRelease the ‘Coffee’ button. |
|
| Preparation starts and the coffee flows into the cup. |
|
| T Press any button as soon as there is sufficient coffee in the |
|
| cup. |
|
| Preparation stops. ‘Saved’ appears briefly on the display. The |
|
| set amount of water for one coffee is permanently stored. |
|
| ‘Please select product:’ appears on the display. |
EYou can alter this setting at any time by repeating the above procedure.
EThe amount can be permanently adjusted to the cup size for the products shown in the product selector too. To do this, press and hold the Rotary Switch k until ‘Enough coffee? Press button.’ appears.
EYou can also permanently set the amount for all specialty coffees, milk and hot water in programming mode (see Chapter 4 ‘Permanent settings in programming mode – Product settings’).
23