S E R V I C E I N S T R U C T I O N S
Part No. 057122
www.keatingofchicago.com1-800-KEATING
Flexible Tubing to Hard Piping Installation
Instructions – for Motor/Pump Part# 055173
Page 1 of 2
Operation #1
Motor/Pump | Filter Tub Assembly | |
See Note #1 | ||
Housing Covers | ||
| ||
See Note #5 |
| |
(2X) |
| |
Motor/Pump |
| |
Housing Assembly | Filter Tub Assembly in Unlocked Position |
90° Compression | Filter Cart Frame Assembly | |
Fitting See Notes | ||
| ||
#3 and #5 |
|
View “A – A” |
|
| |
Pull Rod |
| Bracket SE Coupler | |
| See Note #4 | ||
See Note #2 | Compression Fitting | ||
| |||
| See Note #3 |
|
Caution:
Make Sure Saftey Glasses are Worn
Notes:1.Drain and clean all oil from filter tub assembly. Remove filter tub assembly from filter cart frame assembly. This assembly will be turned over (upside down), for replacement of parts and adjustment to mating part on motor mount housing assembly.
2.Remove pull rod and set aside; this part will be used later.
3.Loosen compression fitting at pump output. Do not remove 90° fitting from pump.
4.Remove (4) bolts holding bracket SE coupler. This assembly will be replaced with new parts in kit. The bracket and flex tubing with quick connect are to be discarded.
5.Inspect 90° compression fitting on the pump as shown in View A – A. If the fitting is not on center line of the radius on the pump mount housing assembly as shown, use a #23 or #24 drill to remove pump housing covers (2) as shown in view A – A, to gain easier access to the top bolts holding the motor/pump. Loosen (4) bolts on motor/pump to center 90° fitting as best as possible. These covers will be
Use these Service Instructions for the following Kit part #’s:
| 057117 | SE14 |
|
057118 | SE18 | ||
057119 | SE20 | ||
057120 | SE24 |
HardPiping057122.qxd