Kenmore 1020, 1030, 1050, 1045, 1040 manual Caring for Machine, Cleaning Oiling

Caring for the	Machine
		CLEANING		AND	OILING
		Fig. 1 Cleaning the feed dogs with a
			brush•
		To insure the best possible operation
		of your machine, it is necessary to
		keep the essential parts clean at all
		times•	Using	a small	brush, remove
		the lint that accumulates in the shuttle
	1	area and around the feed dogs.
		Fig. 2 Parts of the Shuttle Assembly
		To Clean the Shuttle Area:
		1. This area must be kept free of dust,
lever--_	.-,---lever	lint and occasional tangled thread.

Shuttle Assembly

Raise the needle bar to its highest point and remove the bobbin case.

, Push levers of shuttle race aside and lift shuttle race cover and shut- tle out.

3. Clean the shuttle race with small brush.

, Put a drop of oil on the center pin of the shuttle and shuttle race.

(see arrows)

Shuttle Race Cover

onted

hook

Shuttle

driver

To Replace Shuttle Assembly:

,Position shuttle race as illustrated

so that shuttle driver is forming half moon on the left side of tile machine•

•Hold shuttle by center pin and po- sition shuttle so as to form a half

moon on the right side. Pointed hook will be on the bottom.

3.Place shuttle race cover into place over shuttle assembly•

Shuttle Race Fig. 2

41