Installing Cooking Components
Important: Before cooking on your grill the first time, wash cooking grids and cooking rack with warm, soapy water. Rinse and dry thoroughly. Season with cooking oil regularly. After cooking is completed, turn grill to HIGH setting for 3 to 5 minutes to burn off excess grease or food residue.
1. Install heat diffusers above burners. Holes in corners of diffusers attach onto pegs in front and back ledge of firebox. Ensure that firebox heat shield is inserted securely into slots. If grill was shipped with shield taped in place, remove tape before using grill.
2.Evenly space cooking grids on the ledge above heat diffusers. (Fig.20)
3.Insert legs of warming rack into the holes in the top of grill bowl side panels. (Fig.20)
Connecting LP Gas Tank to LP Grill 1.Remove the screw on tank bolt & take off the
washer. Insert the tank bolt from rear of the grill and reinstall the washer & screw set. From Rear of the
cart, place foot ring of 20 Ib tank into the hole in bottom panel. Make sure the tank valve is in OFF position. Use the tank bolt to secure the tank in a fixed position (Fig.21).
2.Check the tank valve to ensure it has proper external mating threads to fit the hose and regulator assembly provided.
3.Make sure all burner valves are in OFF position.
4.Inspect the valve connection port and regulator assembly. Look for damage or debris. Remove any debris. Inspect hose for damage. Never use damaged or plugged equipment.
5.When connecting regulator and hose assembly to tank valve hand tighten quick coupling nut clockwise to a full stop (Fig.22) Do not use a wrench to tighten
because it could damage the quick coupling nut and result in a hazardous condition.
6.Open tank valve fully (counterclockwise). Use a soapy water solution to check all connections for leaks before attempting to light your grill. If a leak is found, turn tank valve off and do not use your grill until the leak is repaired.
CAUTION: When the appliance is not in use, gas must be turned off at the supply tank.
Figure 20
Figure 21
Figure 22
Regulator Connection
Congratulations
Your Kenmore gas grill is now ready for use. Before the first use and at the beginning of each season (and whenever the LP gas tank has been changed):
1.Read all safety, lighting and operating instructions.
2.Check gas valve orifices, burner tubes and burner ports for any obstructions.
3.Perform gas leak check according to instructions found on next page of the manual.
12
