CAUTION
SPIDER ALERT!
IMPORTANT: Always ensure that the venturi burner tubes are clean. A venturi burner tube has a narrow area in
which spiders tend to build nests.
If you noticethatyour grill is getting hard to light or that the flame isn't as strong as it should be, take the time to check and clean the venturi's.
CONTROL PANEL
In someareasof the country,spidersor smallinsectshavebeen knownto create"flashback"problems.Thespidersspinwebs,build nestsandlayeggsinthe grill'sventuritube(s)obstructingtheflowof gasto the burner.The
To preventflashbacksandensuregoodperformancethe burnerand venturiassemblyshouldbe removedfromthe grillandcleaned
kLefo!eusewheneve!the g!i!!has beenid!efo! an extended periodj
Storing Your Grill •Clean cooking grates. •Store in dry location.
•When LP cylinder is connected to grill, store outdoors in a
•Cover grill if stored outdoors. Choose from a variety of grill covers offered by manufacturer once available.
•Store grill indoors ONLY if LP cylinder is turned off and Disconnected, remove from grill and stored outdoors.
•When removing grill from storage, follow "Cleaning the Burner Assembly' instructions before starting grill.
Cleaning the Burner Assembly
Follow these instructions to clean and/or replace parts of burner assembly or if you have trouble igniting grill.
1.Turn gas off at control knobs and LP cylinder
2.Remove cooking grates and flame tamers.
3.Remove screws and carryover tubes from rear of burners.
4.Remove screw and washers to disengage burner from b.racketon firebox.
5.Remove screws to detach electrode from burner. Electrode should remain in firebox.
6.Carefully lift each burner up and away from valve openings.
We suggest three ways to clean the burner tubes. Use the one easiest for you.
(A)(Bend a stiff wire (a light weight coat hanger works well) into a small hook. Run the hook through each burner tube several times.
(B)Use a narrow bottle brush with a flexible handle (do not use a brass wire brush), run the brush through each burner tube several times.
(C)Wear eye protection: Use an air hose to force air into the burner tube and out the burner ports. Check each port to make sure air comes out each hole.
7.Wire brush entire outer surface of burner to remove
food residue and dirt.
8.Clean any blocked ports with a stiff wire such as an open paper clip.
9.Check burner for damage, due to normal wear and corrosion some holes may become enlarged. If any large cracks or holes are found replace burner.
VERY IMPORTANT: Burner tubes must reengage valve openings. See illustrations at right.
10. | Attach electrode to burner. | Correct |
11. | Carefully replace burners, | engagement |
12.Attach burners to brackets on firebox.
13.Reposition carryover tubes and attach to burners. Replace flame tamers and cooking grates.
