Kenmore 152.85254 owner manual How It Works, Set Up

HOW IT WORKS

The air cleaner has a two-stage filtering system. The first stage is a charcoal pre-filter. The second stage is the HEPA (High Efficiency Particulate Arrestor) filter. Room air is drawn into the Air Cleaner through the Air Intake Grille and passes through the filters. The filtered air is released from the top of the unit and is dispersed upwards into the room.

Two Filter Change Calendar Wheels are provided on the

Air Cleaner control panel to serve as convenient reminders when to change the filters.

SET UP

Your Air Cleaner was thoroughly inspected and tested at the factory prior to packaging. Visually inspect it upon removal from its box. Remove and discard any packaging material. Return the unit if it shows any signs of damage or mishandling.

Upon starting your Air Cleaner, set the Pre-filter Calendar Wheel ahead 3 months and the HEPA Filter Change Calendar Wheel ahead 12 months to remind you when the next filter replacement is needed.

ELECTRICAL HOOKUP

Plug the Air Cleaner into a polarized 120-Volt AC wall outlet.

i Z_WARNiNG: To avoid the risk of fire or electric shock hazard, the i Air Cleaner should ONLY be plugged into a polarized 120=Volt AC outlet.

OPERATION

Z_ CAUTION! NEVER operate the Air Cleaner without the

HEPA filter properly installed. Permanent motor damage could result.

Each time you start the Air Cleaner, it is a good idea to run it

at Turbo speed for a few seconds. Then set it HI, MED or LO as desired.