Panasonic SCHT56 operating instructions Settings, Distance

	Settings	Display
		Switch on.
Change the settings to suit your equipment
to the environment in which you are using
it. Before making any changes, read the
descriptions of the settings, note the factory
settings and ranges, and refer to the
equipment's instructions.

1 Enter the	2 Select the item you want to change.	3 Change the	4 Exit the
setup mode.		setting.	setup mode.

Press and hold.

Note

2a Select and press [ENTER].

DISTANCE ↔ AUTO SETUP ↔ INPUT MODE ↔ HDMI ↔ DRCOMP ↔ ATTENUATOR ↔ REMOTE ↔ TV DELAY ↔ RESET ↔ EXIT

•Refer to pages 13 and 14 for each item settings.

•For “REMOTE”, refer to page 21.

•For “RESET”, refer to page 19.

2b Select and press [ENTER].

Press to change the	P ress repeatedly
setting.	until “EXIT” appears.

Press once to enter.	Press [ENTER] to
	completely exit the
	setup mode.

Settings

Auto speaker setup calibration will give optimal result for “DISTANCE”. Therefore, you are unable to adjust the setting manually.

Distance	• Enter the distance of the front, center and surround speakers from
	the seating position.

Change the distance so that the sound from all the speakers (except for the subwoofer) reaches you at the same time.

You can select distances between 3 feet and 30 feet.

The factory settings are: LR (front):	10 ft (feet)
C (center):	10 ft (feet)
S (surround):	5 ft (feet)

Auto setup • Reset the settings done in auto speaker setup.

YES: Reset all auto speaker setup settings

NO: To cancel (factory setting)

Input mode • This unit automatically detects whether input is digital or analog, but you can fix the input mode.

AUTO: The unit automatically detects whether input is digital or analog. (factory setting)

ANALOG: Select to make the unit accept analog input.

DIG: Select to make the unit accept digital input.

PCMFIX1: Select to input to PCM.

2a	2b	3
DISTANCE	LR

C3 feet to

30 feet

S

Repeat for each speaker channel

AUTO SETUP	DEFAULT	NO
		YES
INPUT MODE	TV
		AUTO
	DVR
		ANALOG
		DIG
		PCMFIX
	DVD

1In rare cases, the unit may have trouble recognizing PCM signals and this may cause the beginning of tracks to be cut off. Select “PCMFIX” if this occurs.

•With DTS, the signals may not be recognized at all. Engage the DTS FIX mode if this occurs.

To engage the DTS FIX mode:

Press and hold [-MENU] and [ENTER] at the same time. “DTS” lights.

To cancel the DTS FIX mode:

Press and hold [-MENU] and [ENTER] at the same time.

The mode cancels when input mode is set to AUTO or when the unit is turned off.

Note

When a FIX mode is on, the unit cannot process other signals. This may cause noise to be output. If this occurs, select an input mode other than PCMFIX, or cancel the DTS FIX mode.

RQTX0175

13

(continue on next page)