Kenmore 17568563 Connection, Sure The Disposer Next, Make, Is Grounded, d.,T,-.-i, Disposer To

SURE THE DISPOSER

NEXT, MAKE

				If the cable leading to the
				disposer does not have a
			Green	ground wire,	use a copper
			Ground	wire that is no	smaller than the
If the cable	leading to	the	Screw	other wire in	your cable. At*
disposer has	three wires,	at-		tach one end of the wire to the

IS GROUNDED.

P'-"Ground

jj/

//Sore,,,

tach the green ground wire to the green ground screw.

Attach the other end of this i ground wire to the metal cold

water pipe. NOTE: Be sure that this cold water pipe is

continuous metal pipe from under the sink to the ground

!:d.,"T",'-.'-i

I

green ground screw on the disposer,

If you have a water meter in

your home, check the meter Io see if there is a wire that

comes across iL If there is no

wire, your cold water pipe is

NOT GROUNDED.

j

B.

/

Ground Wire

-- ff6 Copper Wire

for 200 Amp. Or Less Electrical Services

(earth). Use only an Under-

writers Laboratories, Inc.

listed (approved) ground clamp to attach the ground wire to the pipe. If non-metal

pipe is used in your home water connections or if plastic

pipe is used in your water supply pipe, you will need a

qualified elacb'ician to install a proper ground. Now, replace the electrical plate.

To properly ground it, add a copper wire as shown at right. Use only Underwriters Labo-

ratories, Inc. listed (approv-

C, COLD , GroundClamp ed} ground clamps to attach wire to pipe.

WARNING: IF NOT PROPERLY GROUNDED, a hazard of electrical shock

may exist. DO NOT reconnect electrical power at main service panel until proper ground is installed. For your safety, DO NOT ground to a gas sup-

ply pipe.

Water Line

D.

_

Water Meter / Ground Clamp

....,,,,,,

PREPARING THE

DISHWASHER DRAIN

CONNECTION.	Lay the disposer on its side and put the tip of your
	screwdriver into the dishwasher drain hole opening
If you do NOT plan to connect	atanangle.
	a

dishwasher drain to the disposer, go on

,tostep14.

Tap the end of the screwdriver with a hammer until

the molded plug pops out. Make sure you take

the Ioose plug out of your disposer.

THE	DISPOSER TO	Lift the disposer and place it so the disposer's three
ITS	MOUNTING	mounting lugs are lined up under the three sink
		mounting assembly screws.

ASSEMBLY.

Then, while holding the disposer in place, lurn mounting ring with the lugs to the right until all three ears are engaged on the mounting assembly. The disposer will new hangs by itself. You will lock this ring later, after the plumbing connections are made.