Kenmore 25354663409, 241579602 (0410), 25354663406, 2535629340N manual Changing Filter, To change

Kenmore Ice and Water Front Filter (some models)

NOTE: If you purchased a refrigerator with a Kenmore ice and Water front filter, please read the following use and care information. This ice and water fluter system fluters water to your ice maker and water dispenser, Utis Uocated in the upper right front corner of the fresh food compartment,

System Startup:

Water suppUydoes not need to be turned off, however, do not use ice and water dispenser while installing filter,

The filter cartridge has already been installed in the filter housing at the factory, Refer to the How The Water Dispenser Works section to properly fill the system with water,

		Changing	the	Filter:
	FiJter	Water conditions		vary throughout the world, but changing the water filter every
		6 - 9 months normally will ensure the highest possible water quality, The Filter
		Status light will turn red after approximately 400 gallons of water has flowed
		through the ice and water dispenser, Also, if the filter has been in a refrigerator
		that has not been in use for awhile (during moving for example), change the filter
		before reinstalling the refrigerator, The dispenser system will also operate without
		filtration (with filter cartridge removed and bypass installed),
		To change	filter:
Bush In 7		It is not necessary to turn the water supply off to change the filter.
and C		1. Turn the ice maker'spower switch to the Off ("O')position (See illustration
To hstalm	To Release	on page 14).

2.Push the Filter Release Button, located to the right of the filter cartridge, to release the filter from the housing. To minimize the possibility of the filter falling out of the housing during removal, it would be best to hold the filter as it moves out toward you.

Order new filter cartridges through the								NOTE: A Small amount ef water may be released during this opeiation:
dealer where you bought the refrigerator,
								You shou!d have a paper towel or dish cloth handy to wipe up any water
or contact the Sears PartsDirect at 1-800-
							that may drip out of the fi!ter or heusing.Two		small holes near the back of
366-PART. it might be good to order some
								the housing have been added for any excess water to escape. It would be
filter cartridges when you first install your
								best to clear away any food near this area on the top shelf in advance of
refrigerator.		Be sure		to ask	for	the
								removing the filter.
Kenmore	replacement cartridge				9911.
							3. Pull the old filter cartridge straight out of the housing.
							4. Discard the old filter.
							5. Remove the new filter cartridge from the packaging and insert into the
		The Kenmore ice and Water						filter housing the same way the old one came out.
							6.	When the cartridge is almost in, you will feel it stop against the clip assembly
		Filter System NGFC 2000 with
		the Kenmore		cartridge		FC		in the back of the housing. The clip assembly holds the filter cartridge
		100 is tested		and certified		by		firmly in place. At this point, you will need to push firmly until the cartridge
		NSF	international,			the		snaps fully in place. When completely in place, the front of the filter cartridge
nationally recognized and respected, not								will be flush with the front of the housing.
for profit, certification			organization		for public		7.	Turn the ice maker'spower switch to the	On ('T')position.
health safety. The Kenmore Filter system is							8.	Fill a glass with water. As you are doing	this, check for leaks at the filter
tested and certified to ANSI/NSF Standards
								housing. There will be noticable spurts and sputters as the system pushes
42 and 53. See performance data sheet for
								the air out through the system and out the dispenser nozzle. This is normal.
specifications. This system should not be
							9. After you have run one glass of water, continue to flush the system for
used on water that is microbiologicalIy
								approximately 3 minutes to assure that the purest water possible is stored
unsafe or with water of unknown quatity
								in the water storage tank.
unless the water has been adequately
disinfected before or after traveling through								IIVIPORTANT: Resetting The Fitter status Light(some		medets)
the filtration		system.
							i After replacing the filter cartridge, it will be necessary to press the
,, Rated Capacity - 400 gallons
							!Reset button located on the ice and water dispenser.This will reset the !
,, Rated service flow - .5 GPM
							Filter Status light. Push the reset button until the green, red and amber
,, Maximum Rated Pressure - 100 PSi
							I!ghts flash (10-15 seconds),: Please refer to the complete dispenser
,, Maximum		Operating	Temp. - 100° F
								operating instructions attached to the inside of the freezer door.

16