Dehumidifier Feature (continued)
4.You can also use the FAN SPEED button to change the fan speed to HIGH or LOW. The indicator light will show the setting you have selected. A higher fan speed will result in quicker moisture removal.
5.The FILTER RESET light will illuminate after 250 hours of operation. At this time, refer to the “Care and Cleaning section to remove and clean the filter. Once the filter has been cleaned, simply press the FILTER button to extinguish the light.
6.The TIMER function enables you to either Delay Start or Delay Stop the unit in the choice from 0.5 hour to 24 hours. If the unit is running, then selecting Timer will turn the unit off after setting hours (Delay Stop). If the unit is off, then selecting Timer will turn the unit on after setting hours (Delay Start).
TIMER setting: First press TIMER button, then to adjust timer setting, tap or hold the 
or
button to change the delay timer at 0.5 hour increments, up to 10 hours, then by 1 hour increments up to 24 hours. The control will count down the time remaining (8,7.5,7, etc.) until the unit either starts or stops. For the Delay Start, the fan speed and humidity maintained will be the same as previous setting. After TIMER setting finishes, pressing TIMER button again at any time will cancel the
TIMER function. The Delay Start/Stop Feature will work until the unit either starts ro stops. Once that happens, the above steps will have to be repeated again.
NOTE: 1. Before entering TIMER setting, the power indicator must be lit to make sure power is being supplied to the unit. 2. Before entering TIMER setting, make sure first pressing HUMIDITY 
or 
button sets one desired room humidity.
6
