Kenmore 253.25003 Dehumidifier Troubleshooting Guide, Dehumidifier Does Not Operate, Fan Noise

Models: 253.25001 253.25003 253.25002

1 11
Download 11 pages 47.88 Kb
Page 10
Image 10
Troubleshooting

Troubleshooting

Dehumidifier Troubleshooting Guide

DEHUMIDIFIER DOES NOT OPERATE.

Check if

Then

 

 

Wall plug disconnected.

Push plug firmly into wall outlet.

 

 

House fuse blown or circuit breaker tripped.

Replace fuse with time delay type or reset circuit breaker.

 

 

The dryness level you selected has been reached.

Dehumidifier automatically shuts off when selected amount of moisture has been

 

removed from the air. If you want to remove more moisture, select

 

'CONTINUOUS' by using the humidity button or knob. After the dehumidifier

 

starts, reset the control to the desired setting.

 

 

Bucket not installed properly.

Reinstall the bucket properly. See “Removing Collected Water“ for reference.

 

 

Water in the bucket has reached its preset level.

Empty bucket and return bucket to position.

 

 

Dehumidifier is not turned on.

Turn unit on.

 

 

“BUCKET FULL“ light is on.

Remove bucket, empty water and reinstall it correctly.

 

 

DEHUMIDIFIER RUNS TOO MUCH.

Check if

Then

Windows or doors near dehumidifier are open to outdoors.

Close all windows or doors to outside.

Area to be dehumidified is too large.

Check with your dealer to see if capacity is adequate.

Air movement through dehumidifier is blocked.

Dehumidifier must be placed in a space that does not restrict air flowing into the

 

rear coil and out of the front grill.

Grill may be dirty.

Use brush attachment of vacuum cleaner to clean grill. See “Care and Cleaning“

 

for reference.

Dehumidifier is in the CONT mode and will remain in this mode .

Use the humidity button or knob to set a RH% higher level.

DEHUMIDIFIER IS OPERATING BUT ROOM IS NOT DRY ENOUGH.

Check if

Then

Humidity setting is too high.

Press the HUMIDITY button or rotate knob to a lower setting to choose

 

CONTINUOUS for maximum dryness.

Dehumidifier has been installed or restarted recently.

The higher the moisture in the room air is, the longer it will take to dry the room air.

Dehumidifier does not have sufficient clearance to operate, or

See “Selecting a Location“ to select a proper location.

air flow to front grill is blocked.

 

Room temperature is too low.

Unit will not operate satisfactorily if the room temperature is below 5 °C(41 °F).

 

See “How It Works“ for reference.

Dehumidifier runs too much.

Refer to some of the causes under DEHUMlDIFIER RUNS TOO MUCH.

FROST APPEARS ON COILS ABOVE BUCKET OR DRIP TRAY.

Check if

Then

Dehumidifier has been turned on recently.

This is normal due to refrigerant rushing through the coil. Frost will usually

 

disappear within 60 minutes.

Room Temperature is too low.

All models will operate satisfactorily at temperatures higher than 5 °C (41 °F).

FAN NOISE.

Check if

Then

Air is moving through the dehumidifier.

This is a normal sound.

10

Page 10
Image 10
Kenmore 253.25003 Dehumidifier Troubleshooting Guide, Dehumidifier Does Not Operate, Dehumidifier Runs Too Much, Fan Noise