SECTION 1
WATER SOFTENER START UP
B. CHECK LIST OF STEP-BY-STEP GUIDES TO INSTALL
To be sure you have done all the steps to install the
softener, read the following list. Refer to the Installa-
tion Manual, part no. 7258997, for
Page numbers referred to are in the Installation
Manual unless otherwise noted.
v" Is the house water flow going INTO the softener valve INLET? Trace piping to be sure. See pages
v" Is the plumbing bypass valve (or 3 valves) set for
SERVICE? Bypass valve(s) should always re-
main in soft water service position. Position in
"bypass" only if needed for softener repairs. See FIG. 14, page
v" Is the valve drain hose connected the right way,
and without sharp bends or kinks that could
stop or reduce water flow? See page
installation manual.
Page numbers referred to are in the Installation
Manual unless otherwise noted.
v" Is the transformer plugged into an inside, al-
ways live, grounded,
manual, and the wiring schematic on page
v" Be sure to restart the water heater. See page 3- 9.
California Efficiency Requirement
Your Kenmore Water Softener has a "High Effi- ciency" feature with an "ON" or "OFF" setting.
This softener setting is shipped in the "OFF"
position, which utilizes the maximum rated ca-
pacity while most often achieving maximum salt
efficiencies. When installing this unit in the State
of California, you MUST turn this setting to the "ON" position which may initiate more frequent
recharges, however it will operate at 4000 grains per pound of salt or higher.
If you wish to turn the Salt Efficiency feature "ON" (_ icon will show in display), follow the
instructions in the Faceplate Timer Features, Sec- tion 2 of this manual.
NOTE: Codes in the state of Massachusetts require installation
by a licensed plumber. For installation, use plumbing code
248- CMR of the Commonwealth of Massachusetts,
sUPPL y
_INLET
plastic
Bypass Valve(s)
Problems, Questions? Call 1- 800- 426- 9345 Kenmore Water Line
