Kenmore 44733 manual Dooropening, Leve/ing Instructions for all Refrigerator/Freezer Pair

This Owner's Guide provides specific operating instructions for your model. Use the freezer only as instructed in this Owner's Guide. Before starting the freezer, follow these important first steps.

mNSTALLATmON

Choose a place that is near a grounded ebctricaI outbL Do Not use an extension cord or an adapter plug.

LEVELING

The freezer must have all bottom corners resting firmly on a solid floor. The floor must be strong enough to support a fully loaded freezer. NOTE: It is Very Important for your freezer to be level in order to function properly, if the freezer is not bvebd during installation, the

door may be misalignedUnpacking and LeveUing and not close or seal

For the most efficient operation, the freezer should be located where surrounding temperatures will not drop below 40 ° F (5° C) or exceed 110 ° F (43 ° C).

Allow the following clearances for ease of installation, proper air circulation, and electrical connections:

Sides	3/8"
Back & Top	1"

*Do Not block the toe grille on the lower front of your freezer. Sufficient air circulation is essential for the proper operation of your freezer.

Refrigerator

cooling, frost, or moisture problems.

To LeveJFreezer:

screws and wood base,

use a carpenter's level to level the freezer from

front-to-back, Adjust the plastic leveling feet in front, SSbubble higher, so that the door closes easily when left halfway

open,

Leveling Feet

Crating

Arid (2) WOOd Bases

,,_

UnpackingandLeveling

Freezer

Installation

Leve/ing Instructions for all Refrigerator/Freezer Pair:

,Remove two Ieg levelers provided in literature bag. While unit is lying on its back for wood skid removal, install both leg levelers in rear of unit.

*Level door of first unit using alI four levelers and slide unit into place. Recheck for levelness and adjust if necessary.

*Measure distance from floor to bottom of door on first unit. Adjust and level second unit so door height matches.

Leg Level Adjustments

o One full turn of alI four Ieg levelers will raise door 5/32". o One full turn of both front leg levelers will raise door

3/16" and tilt top of door back 7/16".

o One full turn of both rear leg levelers will lower door 1/32" and tilt top of door forward 7/16".

o One full turn of both side Ieg levelers will raise door 3/16" and tilt top of door 3/8".

Slide second unit into place leaving a minimum gap of 3/16" between units for door swing clearance.

This Iast step may require at least one extraction of the second unit to properly align units in a "built-in" application.

DOOROPENING

/Shelf Front