TO LEVEL REFRIGERATOR:
After discarding crating screws and wood base, use a carpenter's ThisOwner'sGuideprovidesspecificoperatinginstructionsfor level to level the refrigerator from front to back. Adjust the plastic
yourmodelUsetherefrigeratoronlyasinstructedthisOwner's.leveling feet in front, 1/2 bubble higher, so that the door closes
GuideBefore.starting the refrigerator, follow these important easily when left halfway open. first steps.
| LEVEMNG iNSTRUCTIONS FOR ALL REFRIGERATOR / |
INSTALLATION | FREEZER PAIR: |
,Choose a place that is near a grounded electrical outlet. DO NOT use an extension cord or an adapter plug.
,For most efficient operation, the refrigerator should be located where surrounding temperatures will not drop below 40°F (5°C) or exceed 110°F (43°C).
,Allow the following clearances for ease of installation, proper
air circulation, and electrical connections:
Sides | 3/8 inch |
Back & Top | 1 inch |
,Do not block the toe grille on the lower front of your refrigerator. Sufficient air circulation is essential for the proper operation of your refrigerator.
1" (25mm)
,Remove two leg levelers provided in literature bag. While unit is lying on its back for wood skid removal, install both leg levelers in rear of unit.
,Level door of first unit using all four levelers and slide unit into place. Recheck for levelness and adjust if necessary.
,Measure distance from floor to bottom of door on first unit. Adjust and level second unit so door height matches.
,Leg Level Adjustments:
,One full turn of all four leg levelers will raise door 5/32".
,One full turn of both front leg levelers will raise door 3/16" and tilt top of door back 7/16".
,One full turn of both rear leg levelers will lower door 1/32" and tilt top of door forward 7/16".
,One full turn of both side leg levelers will raise door 3/16" and tilt top of door 3/8".
,Slide second unit into place leaving a minimum gap of 3/16" between units for door swing clearance.
,This last step may require at least one extraction of the second unit to properly align units in a
Freezer
Plastic | Raise |
Leveling Feet |
|
(lOmm)
Crating
Screw
jJ
Discard The (4) C | /J |
And (2) Wood Bases
DOOR OPENING
NOTE: If your refrigerator is placed with the door hinge side against a wall, you may have to allow additional space so the door can be opened wider.
LEVELING
The refrigerator must have all bottom corners resting firmly on a solid floor. The floor must be strong enough to support a fully loaded refrigerator. It is VERY IMPORTANT for your refrigerator to be level in order to function properly. If the refrigerator is not leveled during installation, the door may be misaligned and not close or seal properly, causing cooling, frost or moisture problems.
