Kenmore 580.72053 owner manual HOW to Install, Bracket Iidrainage

INSTALLATION

Pick a location which will allow you to blow the cold air into the area you want. Windows used for installation must be strong enough to support the weight of the air conditioner. Good installation with special attention to the proper position of the unit will lessen the chance that service will be needed.

HOW TO INSTALL

HGUIDE PANELS

Insert the guide panels into the guides of the air conditioner. Fasten the curtains to the unit with screws (ITEM A), as shown in FIG. 2.

ITEM A FIG. 2

IP_I SEAL STRIP

Cut the adhesive-backed seal strip (ITEM D) to the window width.

Remove the backing from the seal strip and attach the seal strip to the underside of the bottom window. (FIG. 3)

(ITEM D)

L_ ATTACH L BRACKET

•Install the L brackets on the outer sill with the short side of the bracket against the back of the inner sill. Install one L bracket 8" to each side of center line. See FIG. 5.

•The bracket helps to hold unit securely in place. Be sure to place bracket edge flush against back of inner sill. See FIG. 5.

•If air conditioner is blockde by storm window frame, see step 9.

INNER SILL

OUTER SILL	ITEM A INSIDE
	LINE

SHORT SIDE

OUTSIDE

L BRACKET FIG. 5

I_IDRAINAGE

First, be sure to insert the drain pipe into base pan before installation.

The air conditioner must be installed with a slight tilt

downward for proper water drainage. The air conditioner will drain the excess condensed water

through the drain pipe.

FIG. 3

I_-] LOCATING UNIT IN WINDOW

Open the window and mark center line with pencil on the center of the inner sill, as shown in FIG. 4.

INNER SILL

=,r I

ROOM SIDE

DRAINPIPE

"_---BASEPAN REAR

DRAIN_

BASEPAN BOTTOM

FIG. 6

-6-