Kenmore 580.75050 owner manual Removal from Window, Secure the Guide Panels, Window Frame

r_ INSTALL THE AIR CONDITIONER IN THE WINDOW

•Carefully lift the air conditioner and slide it into the open window. Make sure the bottom guide of the air conditioner drops into the notches of the L brackets

•When the air conditioner drops into the L brackets, the

air conditioner will be centered in window opening as shown in FIG. 7

•While steadying the air conditioner, carefully bring the window sash down behind the upper guide of the air conditioner, as shown in FIG 8.

CENTER LINE FIG. 7

FIG. 8

U SECURE THE GUIDE PANELS

Extend the guide panels (ITEM G) to fill the window opening using 2 ITEM B and 2 ITEM C screws to secure them, as shown in FIG. 9

f_J INSTALL THE FOAM SEAL AND SASH LOCK

•Cut the foam seal (ITEM F) to the window width Stuff the foam seal between the lower and upper window sash to prevent air and insects from getting into the room, as shown in FIG. 9

•Fasten the remaining L bracket on either side of the window using screw (ITEM A) See FIG. 9 inset. Installing this bracket prevents unit failing from window being raised

LBRACKET

FOAM SEAL

_,TEM

FIG. 9

QIF AIR CONDITIONER IS BLOCKED BY STORM

WINDOW FRAME

•If storm window presents interference, fasten a 2" wide wood strip to the inner window sill across the full width of the sill. The wood strip should be thick enough to raise

the height of the window sill so that the unit can be installed without interference from the the storm window

frame. See FIG. !0.

Top of wood strip should be approximateIy 3/4" higher than the storm window frame to help condensation to drain properly to the outside.

•Install a second wood strip (approximately 6" long by 11/2''wide and same thickness as first strip) in the center of the outer sill flush against the back of the inner sill.

Screw the L brackets into this strip.

This will raise the L bracket as shown in FIG. 10.

WOOD STRIP MOUNTED		l'rMAX
ON TOP OF INNER SILL		3/4"
		CLEARANCE _
		WINDOW
INNER		FRAME
SILL	WOOD STRIP

OUTER

SILL

INSIDEFOR L BRACKET I ! I TStOE FIG. 10

REMOVAL FROM WINDOW

Turn the air conditioner off, and disconnect the power cord. Remove the L bracket and the screws installed

through the top and bottom of the guide panels, and save for reinstallation later. Close the guide panels. Keeping a firm grip on the air conditioner, raise the sash, and

carefully tilt the air conditioner away from you to drain any condensate water. Lift the air conditioner from the window

and remove the foam seal from between the windows.

_!_ [*Y:TIJ i [*] _1

°Airconditionerscoveredin thismanualposean

excessiveweighthazard.Twoormore peopleare neededto moveandinstallthe unit.

To preventinjuryor strain,useproperliftingand carryingtechniqueswhen movingunit.

°Whenhandlingthe airconditioner,becarefulto avoid cutsfromsharpmetalfinsonfrontand rearcoils.

°Makesure airconditionerdoes notfall duringremoval.

-7-