Kenmore 59771, 59778 Defrost Water Pan, Behind Refrigerator, Light Bulb Replacement, Condenser

8.if tapeholdsbottomdrawercoverto drawer supports,removethetaperPulldrawerpartwayout,, Reachin, pushthe rearof theglassupand,at the sametime,back,until it clearsfront-cornerretainers.

9.Tilt and remove the cover°

10, Tilt and remove the draweFo

After cleaning, replace drawers and covers in reverse order. Reinstall the gasket at the rear of the top drawer. Fit the end of

the plastic drawer support into the slot on the gasket, with the rubber gasket flap facing you. Make sure the gasket snaps into place.

Then replace the light panel by hanging top of panel on upper pins and pushing in at bottom_

Drain Opening in Freezer Compartment

During yearly cleaning, remove the freezer bin and flush a solution of baking soda (one teaspoon) and two cups of hot (not boiling) water through the drain line with the help of a meat baster. This will help eliminate odor and reduce

the likelihood of a clogged drain lJne.

if drain becomes clogged, use a meat baster and

baking-soda.and-water solution to force the clog through the drain line, Continue flushing until the line is clear, then empty and replace the defrost water pan immediately.

Condenser

The condenser is located behind the base grille,, For most efficient operation, remove the base grille (see page 3) and sweep away or vacuum up dust

that is readily accessible_ This easy cleaning operation should be done at least once a year.

Defrost Water Pan

The pan behind the base grille should be cleaned at least once a year. When reinstalling the pan, firmly push it ALL THE WAY IN until it stops°

Behind Refrigerator

Take care moving your refrigerator away from the wall All types of floor coverings can be damaged, particularly cushioned coverings and those with embossed surfaces. Pull the refrigerator straight out and return it to position by pushing it straight in. Moving refrigerator in a side direction may damage floor covering or refrigerator.

Light Bulb Replacement

Unplug refrigerator before changing a light bulb.

Fresh Food Compartment--Upper Light

1.Pul! bottom of light panel forward until panel clears pins on rear wall,

then rotate panel downward until tabs slide

out of slots in control housing.

2.After replacing with standard 60-watt bulb,

reinstall light panel by (1) sliding tabs at front of light panel into slots in control housing, and (2) flexing rear portion of light panel over pins on rear wall,

Fresh Food Compartment_Lower Light

1.Remove light panel. See Storage Drawers, Step 3, on page 12.

2.After replacing the 40-watt appliance bulb with a

same-size bulb, replace light panel by hanging top of panel on upper pins, then pushing in at bottom.

Control Housing

Bulb compartment between freezer and fresh food compartment controls contains two 7-watt screw-in bulbs.

1.Slide butb compartment cover on underside of

control housing back about 1/2 inch and it will drop into your hand°

2.Replace with same- size, same-type bulbs.

3.Line up tabs on cover with grooves in control housing and slide cover forward into place°

Freezer Compartment

1.Remove shelf just

below light panel. (Shelf will be easier to remove

if it is emptied first,)

2.Pull plastic light panel toward you_ (It will bend to free tabs from grooves°)

3.After replacing with same size bulb, reinstall

panel and shelf.

13