Kenmore 625.343950, 625.343920 manual Assemle Install Fauet, Model

INSTALLATION STEPS

STEP 3 - ASSEM￿LE AND

INSTALL FAU￿ET

N￿te: If the faucet is not assembled, slide the lever over the cylindrical nut. Then, push or turn the spout into the faucet body.

1. St￿n￿￿r￿ F￿u￿￿t, FIG. 4A:

A. Slide the chrome washer, large rubber washer and lock washer, in that order, onto the faucet stud.

￿. Put a few wraps of Teflon tape on the end of the faucet stud. Using the washer, turn the tubing adaptor onto the faucet stud and tighten securely.

￿. On the underside of the sink or countertop, in7 sert the large steel washer between the lock washer and the bottom of the sink or countertop. Then, tighten the hex nut securely.

D. Insert the faucet stud through the mounting hole.

2. El￿￿troni￿ ￿￿s￿ F￿u￿￿t, FIG. 4￿:

A. Slide the small rubber washer and electronic indicator base onto the faucet stud. Turn on and tighten the hex nut, ￿ut ￿o not ov￿rtight￿n ￿n￿ ￿r￿￿k th￿ ￿￿s￿.

￿. Put a few wraps of Teflon tape on the end of the faucet stud. Using the washer, turn the tubing adaptor onto the faucet stud and tighten securely.

￿. Looking at FIG. 4C, locate the faucet support and gasket over the sink or countertop mounting hole. (First, break out the small button and save for use in step G below.)

D. Turn the special nuts (FIG. 4D) a few turns onto the 1-3/8" long screws.

E. Place a screw into a notch in the faucet sup7

FIG. 4

A

MODEL 625.343920

spout

lever

faucet

chrome washer

rubber washer (large)

steel washer (large)

lock washer

hex nut

washer tubing adaptor

compression nut

C

gasket

plumbers

putty

B

DELUXE

MODEL 625.343950

spout

lever

faucet

screw

rubber washer

electronic faucet base

hex nut

washer

tubing adaptor

compression nut

button (use in step 2G)

faucet

support

mounting

hole

port, with the special nut on the underside of the mounting hole (FIG. 4E). Use a finger to hold the nut while tightening the screw until snug. Repeat with the remaining screw and special nut. Be sure the support is positioned correctly, then tighten both screws evenly so the support is held firmly in place.

F. Insert the faucet stud and base leadwire through the support and mounting hole.

G. Lower the faucet and base down onto the sup7 port, being careful not to pinch the leadwire. Use the 5/8" long screw to fasten the faucet base and support together. Insert the button (from step C) into the hole to cover the screw.

D

screw (2)

nut (2)

	E
	TOP VIEW
mounting	screw (2)
hole

faucet

supportnut (2) - under7 side of mount7

ing hole

6