INSTALLATION STEPS
STEP 4 - MAKE TUBING CONNECTIONS
1.Allowing some slack, measure and cut a length of 3/8" tubing to connect between the tubing adaptor, at the supply saddle valve, and the filter system inlet, FIG. 1. Cut the ends of the tubing square.
2.Slide a compression nut onto both ends of the tub0
ing. At the filter system end, push a tubing insert into the tubing.
3.Connect the tubing and tighten the compression nuts securely.
4.Repeat steps 2 and 3 to connect tubing between the filter system outlet and the adaptor on the bottom of the faucet stud, FIG. 1.
STEP 5 - BATTERY PACK INSTALLATION AND CONNECTION, DELUXE MODEL ONLY
1.In a dry location, within reach of the electronic base 3 ft. leadwire, select a place for the battery pack (see FIG. 1). The battery pack attaches to most surfaces with a ``
2.The battery pack uses 2, size AA batteries. Check to be sure they are installed correctly. Then, remove the paper backing on the Velcro strip and secure in place.
3.Fasten the electronic base leadwire connector and battery pack connector together.
STEP 6 - FILTER CARTRIDGE INSTALLATION
Turn to page 9 and follow all steps under ``Filter Cartridge Replacement''.
7
