Graco PD108195A, 1749531 owner manual Installing the Infant Restraint and Base Using Vehicle Belt

3. Buckle the vehicle belt. Make sure the buckle	
tongue goes into the correct buckle . The seat
belt should not be twisted or turned.

4.Tighten the vehicle seat belt. Refer to your

vehicle ownerÊ s manual and the instructions in „ 6.2.2 SAFE Vehicle Belt Systems‰ , page.29-31, on tightening your vehicle belt when using the infant restraint without base.

To create a secure installation, push down	
hard with your free hand on the infant
restraint  and pull and tighten the
vehicle belt.

5. Test infant restraint for secure installation as described in infant restraint „ Final Safety Check‰ page.40.

7.2Installing the Infant Restraint and Base Using Vehicle Belt

When using the base to install the infant restraint, the lock-off is ALWAYS used to secure both belts of the lap or lap/shoulder belt.

1.Place the base in a rear-facing position on a vehicle seat.

2.Open the lock-off and route the vehicle belt through the belt path and over the lock-off.

Lock-off

34