7.3Using LATCH to install Base
1.For ease of installation, extend LATCH to its maximum length and remove from storage bars.
2.Position base in vehicle seat as shown.
3.Make sure LATCH is through
vehicle/LATCH belt path normally used for vehicle seat belt. .
Belt must lay flat and not be twisted.
4.Hook Connectors to vehicle lower anchors. Pull firmly on Connectors to be sure they are attached .
5.Tighten LATCH by pushing down hard on base and pulling the
adjustment belt .
6. NEVER put two LATCH connectors on one vehicle LATCH anchor unless specifically allowed by the vehicle manufacturer .
7. Test infant restraint for secure installation as described in infant restraint „ Final Safety Check‰ page.40.
8.Check that the LATCH stays tight and does not slip from the tightened position. If it does not stay tight, try another
seating position or contact Graco at
37
