Kenmore 625.348242, 625.348252, 625.348235 Program, Timer, SET Days to Recharge, SET Recharge Time

SECTION 1 iWATER

C. PROGRAM

2.SET DAYS TO RECHARGE

This setting is the number of days the filter will go

between recharges. The default setting is 3 days,

with a maximum setting of 99.

FILTER START UP

THE TIMER

3. SET RECHARGE TIME

The filter is factory set to begin recharge at 12:00 AM.

If a different recharge time is desired, or needed, do the following.

3- .ot

RECHarGE

ao Press the UP or DOWN buttons until the correct

number of days between recharges is shown in the display.

b.Press the SELECT button once to set the days to recharge and advance to the next set up screen.

For iron applications, see the chart below to deter-

mine the frequency of recharges. Find the number of

people living in the household, and then going across the chart, find the amount of iron (in parts per million) that is in the water supply. The number of

days that shows in the chart is the number of days the filter should be set for recharges.

NOTE: Carbon and neutralizing filters may only

need to backwash using the default schedule (3

days), depending on application. If the water sup-

ply has high turbidity (sand, silt, sediments, etc.) set

the filter to regenerate more often than the 3 day schedule.

ao

Do

Press the UP or DOWN buttons until the correct

recharge time is shown in the display.

Press the SELECT keypad once to set the re-

charge time and return the display to the nor-

mal operating screen with the present time of day shown.

For oxidizing		iron	applications:
						Iron (parts	per million)
Number	of People			1- 2		3- 4	5- 7		8-	20
	1		4	days	3	days	2 days		1	day
	2		4	days	3	days	2 days		1	day
	3		4	days	3	days	1	day	1	day
	4		3	days	2	days	1	day	1	day
	5		3	days	2	days	1	day	1	day
	6		2	days	1 day		1	day	1	day
	7		2	days	1 day		1	day	1	day

1-4

Problems, Questions? Call 1-800-426-9345 Kenmore Water Line