SECTION 2
HOW YOUR WATER SOFTENER WORKS
2A.FACE PLATE TIMER FEATURES
EXTRA RECHARGE
Sometimes, a manually started regeneration (re; charge) may be desired, or needed. Two exam; ples are:
--You have used more water than usual (guests visiting) and you may run out of soft water before the next timer started regeneration.
--You did not refill the softener with salt before it was gone.
You can start a regeneration right away, or you can set the timer to regenerate at the next 2:00 AM (or other preset recharge time). Do the following.
PROGRAM MEMORY
If electrical power to the softener goes off, the time display is blank but the face plate timer keeps the correct time for about 6 hours. When electrical power comes on again, you have to reset the present time only if the display is flashing. The HARDNESS and RECHARGE TIME never require resetting unless a change is desired.
Even if the timer is incorrect after a long power outage, the softener works as it should to keep you water soft. However, regenerations may occur at the wrong time of day until you reset the timer to the correct time of day.
RECHARGE NOW
Press the ON/OFF±HOLD button and hold for 3 seconds. The softener enters the fill cycle of regeneration right away. . .the display shows ``FillinG NOW''. This regeneration will last for
about 40 minutes. Then, you | NOW |
will have soft water again. |
|
RECHARGE TONIGHT
■ Press and release (DO NOT HOLD) the |
CHARGE TONIGHT flashes |
in the display, and the soften- |
er begins regeneration at the |
ERROR CODE
An error code could appear in the face plate display if a problem occurs in the softener electronics. If you see an error code instead of the time of day, please call you local Sears Service Department for service.
SOFTENER STATUS DISPLAY
1.SERVICE ( PROVIDING SOFT WATER) POSITION: The display shows the present time of day. If ``TURBINE is flashing, soft water is currently in use.
TURBINE
..
PM
next preset recharge time. Press and release |
the |
decide to cancel the regeneration, and RE- |
CHARGE TONIGHT. |
2.RECHARGE POSITIONS:
A. Fill Cycle - FillinG NOW shows in the display. If soft water is being used, ``TURBINE flashes.
B. BRINING, BACKWASH AND FAST RINSE CYCLES - The dis; play shows the minutes of re; charge remaining before return to soft water service. RECHARGE NOW is also flashing.
TURBINE
NOW
..
RECHARGE NOW
IF YOU NEED HELP ON THE USE OF THE TIMER FEATURES, CALL TOLL FREE,
NUMBER 1±800±426±9345.
10
